That did the trick, although I did have to slow the Baud rate down to 9600 bps. The only way you can get it back into Run is via the software (**** I know), so then we had the problem of the comm's.Īfter inspecting the comm's lead that was being used, I noticed it was plugged into the laptop's parallel port (silly), So I rigged a USB to RS232 to SNP lead as there was no standard RS232 serial port on the laptop. Output card I was given to replace with was not a 16 O/P card, but an 8 O/P card, hence the CPU did not recognise the hardware. Many thanks for all the replies to this I managed to sort the problem out.
0 Comments
Leave a Reply. |